Full range of granulators for small bottles,tanks and jerry cans to 200 litre, coex fuel tanks 15 kg, IBC container, without pre-cutting.
In line grinding of pieces from blow moulding and runners to 180°C.
23.000 bottles/h of 0,75 liter ground at start up, whithout fly-back.
Regrind quality material
Homogeneous and uniform regrind constantly produced. Mechanical and physical properties of plastics unchanged. Increased gripping ability for a bigger productivity thanks to the cutting chamber section, especially for voluminuos and light small blow mouldings.
Efficient solutions
Water cooling, side discs, antiwear chamber, open rotor and specific chamber section allow in line grinding of pieces from blow molding and top&tail up to 180°C
Applications
Energy efficiency
Lowest running cost expressed in kWh/kg available on the market. Reactive power cosϕ reduced to minimum thus having a direct impact on hourly energy cost. Combined effect with different cutting angles (arrow and scissor) to minimize cutting effort.
Easy operation and maintenance
Reduced maintenance frequency and downtime by advance engineering design. Safety of operator during use and maintenance.
Bottles
Jerrycans
Fuel tanks
Drums up to 220 lt
BM SERIES
Granulators dedicated to the recovery of blow moulding scraps: runners, blown pieces, in-line parison at high temperatures. Off-line grinding of preforms and blown pieces. Suitable for moulds or bulky and light thermoformed scraps.